Building basics2026-11-15T18:16:21+01:00

Choose a product group

Metal roofing

Sandwich panels

PIR insulation boards

XPS

Accessories

Fencing

Building basics

Sandwich-panel.pl explains the basics of choosing sandwich panels, PIR insulation boards and metal roofing. Learn how the core differs from the facings, what the thickness describes and how the sheet dimensions relate to the effective cover area. The guides are intended for people planning a garage, industrial building, workshop or farm building. They explain which details to collect before ordering, how to identify accessories and what to inspect when the goods arrive. Use the articles to compare materials and prepare the questions that need to be resolved for your project.

Mineral wool wall panels: how to read the U-value and thermal conductivity

Various heat-related figures appear on the material label and in the panel datasheet. Lambda describes conduction within the material, while U helps assess transmission through a building element or product in a specific configuration. These values are not interchangeable. Distinguishing between them makes it easier to select the wall of a workshop where people will be working throughout the day. The thermal conductivity coefficient is written as lambda and given in W/(m·K). At the same thickness, a lower value means greater thermal resistance of a homogeneous layer. However, the value appropriate to the specific core and the adopted calculation method must be used. A figure from any mineral wool mat should not be taken to calculate a sandwich panel.

Snow stops or snow fences? Choosing snow retention for a roof

The choice between snow guards and snow fences depends mainly on the role the protection is to play on a given roof slope. It is worth checking the roof length and pitch, local snow conditions and areas requiring protection, such as entrances or walkways. Equally important is matching the fixings to the covering and structure. The article explains how small point elements differ from continuous barriers and why their layout should follow a technical solution rather than chance.

Where can you use T14 steel sheet, and how should it be supported?

T14 trapezoidal steel sheet can serve as a lightweight covering or cladding. However, its suitability is not determined by the name alone. The profile shape, steel thickness, supports and load are what matter. A sheet over an open shelter is selected differently from one on a workshop wall. Start with the building's function. Only then compare dimensions and price. The letter T indicates the family of sheets with a trapezoidal cross-section. The number refers to the nominal profile height. It does not describe the thickness of the steel core. A T14 sheet is therefore not a sheet 14 mm thick. It is a thin sheet stiffened by ribs.

What do purlins do in a roof or steel-framed building?

Purlins are structural members that support other parts of a roof or its covering directly – in a house they work with rafters, while in a hall they work with trapezoidal sheet or sandwich panels. When choosing, it is worth checking not only the covering profile but above all the spacing and width of supports, the span arrangement and the required loads, as these determine the section selection. A higher sheet profile alone does not allow supports to be spaced arbitrarily. The supplier also needs the layer build-up and fixing method, and the documentation should state who is responsible for the calculations and section selection.

Choosing a timber roof structure and organising the carpentry work

Choose the truss type only after establishing the roof geometry and the points that can carry loads — these, not the amount of timber, determine the arrangement. Check that the planned covering, together with battens, insulation and finish, is included in the design, and whether attic needs require a post in an unsuitable place. Compare the completed structure on the same assumptions, including connections and assembly. Leave the assessment of the scheme to the designer, who will match the arrangement to the actual support conditions.

Reading roof pitch in degrees and as a percentage

The key is to establish whether the manufacturer states the minimum in degrees or as a percentage — the two are not interchangeable. The building owner and the trade should therefore check the unit in the instructions and the conditions under which it applies, then compare these with the actual roof pitch. Account must also be taken of the horizontal projection rather than the slope length, possible installation tolerances and places where water may collect. Only on this basis can it be judged whether a given roofing system is suitable or whether the design needs to change.