Building basics
Sandwich-panel.pl explains the basics of choosing sandwich panels, PIR insulation boards and metal roofing. Learn how the core differs from the facings, what the thickness describes and how the sheet dimensions relate to the effective cover area. The guides are intended for people planning a garage, industrial building, workshop or farm building. They explain which details to collect before ordering, how to identify accessories and what to inspect when the goods arrive. Use the articles to compare materials and prepare the questions that need to be resolved for your project.
IKO enertherm ALU TG: joints within the field and at the perimeter of the insulation
The ALU TG tongue-and-groove joint organises the connection of adjacent boards within the field. At the perimeter and around openings, cuts may occur that remove part of the factory geometry. The system should allow for such terminations. It cannot be assumed that the TG designation resolves the sealing of all cut edges. The cross-section under consideration comprises thermal insulation joined with a factory tongue and groove. The function of IKO enertherm ALU TG must be described together with the layers adjoining its surface. An important point of connection is the edge of a cut piece without a preserved factory tongue. The basis for coordination is a row plan indicating the edges remaining after cutting. Before selecting materials, the width of the last strip and the position of the joint terminations must be established so that the sequence of layers has a real reference.
How do you choose the wool thickness when a building has a warm and a cool section?
Not every wall has the same job. A single building may contain a heated workshop, a cool store and a small sanitary back room. When choosing a mineral wool panel, it is worth starting with a map of these zones. The 60–200 mm range is a convenient point of comparison, but it is not a universal set of answers for every function and every system. Mark which rooms will be heated continuously and which only during visits. Also establish the temperature in adjacent zones. A wall separating a warm workshop from a cool store also transfers heat, even though it is inside the building. It cannot be treated in the same way as a partition between similarly heated rooms.
What does a roofing underlay do and how do you choose one?
The underlay membrane beneath metal roofing is there to intercept water that gets under the covering and direct it outside before it reaches the insulation or structure. When choosing, check whether the manufacturer allows installation on the given substrate, along with water resistance, temperature range and the durability of joints. The Sd value alone does not settle suitability, because the whole roof assembly matters. Also establish how laps and the eaves termination are detailed, since these determine how the membrane performs in practice.
What to look for during an autumn roof inspection
Base the autumn roof inspection on a comparison with earlier checks rather than assessing it from scratch. Document the condition of the surface, details, drainage and layers visible from the loft, recording specific defects instead of a general impression. The key decision is separating urgent securing from planned work, so note the location, description and date, and attach labelled photos. Remember events since the last inspection, such as gales or hail, which may have affected the coating, flashings or fixings. Choose conditions that allow safe inspection.
Where to look for corrosion on metal roofing and how to prevent it
Protecting a metal roof from corrosion starts with the choice of coating, which should be matched to the local environment before the sheets reach the site. Check the type of metallic layer and organic coating, and assess the suitability of the outer and inner faces separately, particularly with a damp or aggressive interior. Colour alone is not enough. Also confirm that the profile and thickness suit the structure and that the protection suits the surrounding conditions. Long-term durability then depends on correct installation, water drainage and control of condensation.
How should supports be selected for a panel wall exposed to wind?
Supports should not be positioned solely for the convenience of column layout. A wall panel carries wind pressure and suction, and its deflection affects both appearance and the performance of connections. The correct spacing results from the loads and the data for the specific product. The number of spans, the width of supports and the parameters of both steel facings are also important. A single panel may rest on two or more supports. The distance between adjacent supports is the span. In the tables, single-span and multi-span arrangements have separate conditions. A more favourable result cannot be selected without conformity with the actual frame.





